Rectract Before Outer Wall not working - ZScar issues - UltiMaker

Hi, I'm having some issues with the zscar, I already try most of the possible combinations with Cura settings and I am continuing having problems as we can see in the image below. - I think the main problem that is causing the issue in the image, is the lack of pressure inside the extruder when i

Rectract Before Outer Wall not working - ZScar issues - UltiMaker

Outer Before Inner Walls - gaps at the beginning wall - UltiMaker

Rectract Before Outer Wall not working - ZScar issues - UltiMaker

outer and inner wall do not attach to one another - Improve your

Compensate Wall Overlaps - causing zits - UltiMaker Cura

Getting better prints - 3DVerkstan Knowledge Base

Outer wall defects, might be a slicer setting issue - Improve your

Feature request: unretract inside region before printing outer

How would one go about fixing this? It's not retract after layer

Retract Before Outer Wall Off and On, and Retraction Extra Prime

5.0 beta] Negative outer wall inset values is accepted but does

Outer Before Inner Walls - gaps at the beginning wall - UltiMaker